Forum

Good Day Does the remote start(Gen Start) come configured automatically on outputs 9 & 10? Is it a voltage trigger or dry contact? Kind Regards Chris

On a Smartgen HGM6120 controller, i changed it to HGM6110 to be able to use input 3 as remote start signal from inverter, in manual mode the gen start normally. In the auto mode when selected now nothing happens untill i close iput 3, then gen starts running and stop delay starts counting 10 sec and start stop and ETS hold. What other settings must be changed for Auto because in manual mode it works?

Hi there, I am using the HGM9410 to control a Ground Power Unit for Aircraft servicing (400HZ, 200V AC) I want to configure the HGM9410 to shutdown after 10 mins waiting a manual close to GEN CONTACTOR. I already have AUX OUPUT 5 configured and wired to open/cloe GEN CONTACTOR. I also have a DIGITAL INPUT 3 (close to active) configured to sense the AC Connector plug to the aircraft (Safety Interlock) I suspect that this can be done with the user custom periods, but i could not find any documentation regarding these functions of the HGM9410 Regards, Patrick Vitrian